Log into the FPR9300-1 Chassis Manager and navigate to Logical Devices. Connect to the FPR9300 Management IP and verify the module hardware. Verify that both FTD appliances meet the note requirements and can be configured as HA units. The two units in a HA configuration must meet the conditions mentioned here. Note: On an FPR9300 appliance with FTD, you can configure only inter-chassis HA. If your network is live, ensure that you understand the potential impact of any command.

All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment.

Firepower Management Center (FMC) - SW 10.10.1.1 (build 1023).2xCisco Firepower 9300 Security Appliance - FXOS SW 2.0(1.23).The information in this document is based on these software and hardware versions: There are no specific requirements for this document. This document describes how to configure and verify Firepower Threat Defense (FTD) High Availability (HA) (Active/Standby failover) on FPR9300.

Cisco firepower 1150